ShenZhen Hong Ye Jie Technology Co., Ltd.

1.RTV molding silicone rubber for plaster products application:   RTV molding silicone rubber for plaster products with 30 shore A, is specially suitable for plaster decoration duplication,gypsum sculpture reproduction,duplicating resin product with fine details,PU resin reproduction,wax molding,stone duplication ,epoxy moulds,pacrylic moulding,reproducing polyester craft.   2. RTV molding silicone rubber for plaster products feature:   (1) RTV molding silicone rubber for plaster products with SGS and ROSH approval (2) Curing agent arrange together as free charged (3) In liquid form and in various colors (4) With an exceptional fluidity and good operability. (5)Temperature and deformation resistance as well as low shrinkage. (6) High duplication times. (7) Sample orders are available 3.RTV molding silicone rubber for plaster products operation way:     Step One:Take 100g of part A and add 2g of part B and mix the silicone rubber and curing agent evenly. Step Two: vacuum pumping.Without exception, this step takes less than 10 minutes. Note: The time for vacuum-pumping should be less than 3—5 mins , otherwise, once the silicone rubber has cross-link reaction during vacuumizing, it will not be operated. Step Three: Brushing cast & Perfusion Molding operation   4.RTV molding silicone rubber for plaster products frequently asked question:   Why is the silicone rubber mold oily? Basically, molding silicone rubber doesn't contain any oil, so it won't be oily. The reasons for the oily molds can be deducted from the below 3 factors:   1. Added white oil, which is the compound of silicone oil and white oil. The white oil is not silicone oil but a kink of petrochemicals;   2. Added too much silicone oil. Normally, we donot advise our customers to add any silicone oil into silicone rubber. If necessary, the ratio must be 5%-10%;   For more information of Silicone Rubber, pls feel free to contact Ms. Tracy Xu: Tel: +86-0755-89948294 FAX: +86-0755-89948030 Skype: silicone011